- Select 'Yes' to add a rectangle or circle cutout
- Add the length and width or diameter of the cutout
- To position the cutout use the ‘Alignment’ section. Click ‘Centre’ to put the cutout in the centre. For any other position click ‘Custom’ and add your offset left and offset bottom measurements in mm.
How do I measure where the cutout should be?
For ‘Offset Left’ measure from the left edge to the cutout edge. For ‘Offset Bottom’ measure from the bottom edge to the cutout edge as in the diagram.
Can I upload my diagram or drawing?
Yes, you can, select ‘Upload’ and then the number of external and internal cutouts you require, you will then be able to upload your image.
An external cutout is around the edge and creates a shape, an internal cutout is inside.
Alternatively, contact us with information about where you require your cutouts.
Cost: £10 per cutout
Please note that our CNC bit is 3mm round so the minimum radius we can cut an internal cutout's corners would be 1.5mm. This means we cannot do sharp 90-degree internal corners.