4mm Plywood Sheet

1. Select ‘Yes’ to add a rectangle or circle cutout.
2. Add the length, width or diameter of the cutout.
3. To position the cutout use the ‘Alignment’ section. Click ‘Centre’ to put the cutout in the centre. For any other position click ‘Custom’ and add your offset left and offset bottom measurements in mm.

How do I measure where the cutout should be?

For ‘Offset Left’ measure from the left edge to the cutout edge.

For ‘Offset Bottom’ measure from the bottom edge to the cutout edge as in the diagram.

Can I upload my sketch?

Yes, you can. Please select ‘Upload’ and then the number of external and internal cutouts you require, you will then be able to upload your image.

An external cutout is around the edge and creates a shape, an internal cutout is inside.

Alternatively, contact us with information about where you require your cutouts.

Drilled holes are holes that go all the way through the wood to create a small hole that you can then use to screw the wood onto something else.

We can save you time and effort by drilling holes for you.

You can select corners, edges or a centre hole.

You can then choose the size of the hole and the distance from the edge for each individual hole. Need them all the same size and distance? No problem, click select all. Don't want one of the holes? Just click on the bin to delete it.

Click +Add Additional Holes to choose edges and corners or to add a centre hole as well.

You can check the hole placement in the visualiser.

Please make sure your selection aligns with the orientation of the product.

If you require more holes or bespoke hole placement, please use our Cutouts option below.

The grain direction is the alignment, orientation, or pattern of the wood fibers in a piece of wood. You can specify if you want the grain to run parallel to the length or the width.

Please specify the direction in which you require the grain of the wood to go.