18mm EGGER H1313 Grey Brown Whiteriver Oak ST10 MFC

We can save you time and effort by drilling your fixing holes for you.

Select from the diagram where you require drill holes, you can then choose a hole diameter and the distance from the edge you would like the holes to be.

Please make sure your selection aligns with the orientation of the product.

If you require more bespoke hole placement or hole larger than 12mm, please use our Cutouts option below.

Edge banding is a protective material applied to exposed edges which not only gives your project a clean and polished look, but also provides protection against wear, impact, and moisture. This results in a more durable and long-lasting product due to the sealed edges of the veneered MDF sheet.

You can choose from matching edges to the board material you are buying, or you can choose a contrasting edge banding for a customised look. Whether you prefer a wood grain, a metallic sheen or a vibrant colour, we have plenty of options for you to choose from to allow you to tailor your creation and create a more premium look to your veneered sheet.

The grain direction is the alignment, orientation, or pattern of the wood fibers in a piece of wood. You can specify if you want the grain on the real wood veneer to run parallel to the length or the width.

Please specify the direction in which you require the grain of the wood to go.

Measure from the top or bottom of the door to the middle of the hinge hole.

Can't I just add hinge holes myself?

Yes, with the right, specialised tools you can but if you're working on a project with multiple doors, having pre-drilled hinge holes ensures consistency in the placement of hinges and saves you the time and effort of adding them yourself.

Properly drilled hinge holes reduces the risk of splitting the wood when inserting screws to attach the hinges. Splitting can weaken the wood and compromise the integrity of the hinge attachment so it’s important these are done correctly by a professional.

How do I add hinge holes to my order?

Step 1. Choose a door orientation:

• Left-Hand Door - swings to the left when you open it
• Right-Hand Door - swings to the right when you open it
• Top-Hung Door - opens upward when you open it

Step 2. Let us know where you want the hinges to be on the door. You can add measurement from the top or bottom of the door to the middle of the hinge hole.

1. Select ‘Yes’ to add a rectangle or circle cutout.
2. Add the length, width or diameter of the cutout.
3. To position the cutout use the ‘Alignment’ section. Click ‘Centre’ to put the cutout in the centre. For any other position click ‘Custom’ and add your offset left and offset bottom measurements in mm.

How do I measure where the cutout should be?

For ‘Offset Left’ measure from the left edge to the cutout edge.

For ‘Offset Bottom’ measure from the bottom edge to the cutout edge as in the diagram.

Can I upload my sketch?

Yes, you can. Please select ‘Upload’ and then the number of external and internal cutouts you require, you will then be able to upload your image.

An external cutout is around the edge and creates a shape, an internal cutout is inside.

Alternatively, contact us with information about where you require your cutouts.